With craftsman’s spirit, A&C always tries to do better.

Toggle Navigation

Silica Sand Mining Process Plant

Psted On 2018-10-17 15:08:51
Silica Sand Mining Process Plant

Silica Sand Mining Process Machine wears too much

The emergence of Silica Sand Mining Process Machine has made the stone processing technology a big step. At present, the Silica Sand Mining Process Machine crushing stone production not only meets the construction requirements of each project in terms of quantity and quality, but also can meet the requirements of mechanized construction. But even the best machines are subject to various external factors such as wind and sun, or their own problems, which makes the efficiency lower. So today we will take a look at the solution of the Silica Sand Mining Process Machine wear and the damage of the Silica Sand Mining Process Machine. The pieces usually include a hammer, a counter lining, a casing liner, and a shield of the rotor body. Among them, the wear time of the hammer is short, and the wear cost is also high. Therefore, reducing the wear of the hammer is the key to solving the wear of the Silica Sand Mining Process Machine. So how to solve such a problem, let's take a look!

The first is the effect of the nature of the material to be shredded. The influence of the material to be crushed on the hammer wear includes: the nature of the material, the size of the feed-size, and the water content. Among them, the influence of the material properties is very large. It can be seen from the table that the corresponding crushed materials are corresponding. The unit pure wear of the hammer is quite different.

The second is the impact of processing capacity and discharge gap. The handling capacity of the Silica Sand Mining Process Machine also has an impact on the hammer wear. When the processing capacity is increased, the product grain size becomes coarser, the crushing ratio is reduced, and the unit pure abrasion of the plate hammer is also lowered, and the discharge is also changed. The gap size can also change the thickness of the product to a certain extent, so it also has a certain impact on the hammer wear.

This is followed by the effect of line speed. Line speed is a working parameter that affects the wear of the hammer. The reason is: the magnitude of the linear velocity directly affects the magnitude of the impact energy exerted by the hammer on the material, the size of the crushing ratio, and plays a decisive role in the particle size of the product. In addition, excessive line speeds may also lead to a sharp increase in hammer wear, because at too high a line speed, the material cannot enter the impact zone (or the penetration depth is small), and the end of the hammer is severely worn. of. Foreign research data shows that the wear of the plate hammer is proportional to the square of the line speed to the square.

The Silica Sand Mining Process Machine produced by our company has excellent low wear characteristics, and the equipment is also used for high abrasion and secondary disintegration production. In addition, due to the zero pollution of the product, the Silica Sand Mining Process Machine can be well adapted to the production of glass quartz sand and other high-purity materials, with a wide range of production capacity, and the Silica Sand Mining Process Machine can meet almost any production requirement.